Page 1 of 1

DCC Power Supply question,

Posted: Tue Feb 05, 2013 2:46 pm
by sandpatch1
for DCC,, can I use a lap top power supply,, I have access to a couple HP Dell power supplies that show 16v at 4.5 amps,, the computers are being replaced and I can have the power supplys,,Can you use these for DCC?
Thanks to the DCC tech's in advance. dave j

Re: DCC Power Supply question,

Posted: Wed Feb 06, 2013 7:31 am
by Dan M
I use laptop power supplies myself and have had no problems. Just be sure you dcc booster's input voltage and amps are not over what it is rated for. Laptop ac adapters produce a nice filtered DC which works well for the DCC system. I use one for my Digitrax booster and command module and another for the NCE one with no problems. I think it was a rated output of 19 volt DC at 4 amps.

Dan

Re: DCC Power Supply question,

Posted: Fri Feb 08, 2013 11:36 pm
by sandpatch1
THANK YOU DAN,,
I have a Digtrax super cheif, 100,, I have 16v 5 amp Dell PS, that the computer died and thought it would work, ,
but can the power supply be larger than the db100, like 19v at 4.5 amp, or 16 v at 4 amps lots of those in the bargin bin at the computer store, do you use a cooling fan? I also have a Fisher Scientific, EMD 224,, (yeah emd) with both 24 ac and 24 dc at 5 amp and it is variable. 0-24 v, but cant find a manual to see if both work or only one side at a time.
dave jakubiec, trying to get this thing fired up,,
life is easy
DCC is Hard.

Re: DCC Power Supply question,

Posted: Sun Feb 10, 2013 12:53 am
by bctrainfan
Best bet would be tech support at Digitrax for an exact answer.

Re: DCC Power Supply question,

Posted: Mon Feb 11, 2013 2:39 pm
by Dan M
For your model from Digitrax: http://www.digitrax.com/products/comman ... rs/dcs100/
Note: Accepts either 50/60 Hz AC or DC input from power supply (sold separately). Recommended power supply: Digitrax PS514 or equivalent. Maximum input 22 volts AC or 28 volts DC Minimum input 12 volts AC or 12 volts DC.
No I do not use a fan and have not needed one. Right now the layout room is still in dismay... no layout in over 6 years! With spring coming this year will be the start of the new layout in HO scale... long time waiting.

Dan

Re: DCC Power Supply question,

Posted: Mon Feb 11, 2013 8:19 pm
by sandpatch1
Thanks Dan, found 2 dells, 16.5 v 6.35 amps, just need a 5 amp fuse, ,, dont worrry 5 years the stuff has been collecting dust,,theirs a train under there somewhere.. It was also pointed out that the digtrax PS is the same design as laptop PS's,, just differ volts & amps, thanks and race you to Promitory summit.
dave jakubiec