Air Pressure
-
- Railroadfan...fan
- Posts: 89
- Joined: Thu Nov 26, 2009 10:37 am
- Location: In Michigan
Air Pressure
If anybody can answer this question, Has the air brake pressure for passenger trains and freight trains always been the same? I seem to recall freight trains using 72 lbs. of air to release the brakes. This was back about '67 or '68. Am I hallucinating?
- SD80MAC
- Ingersoll's Mr. Michigan
- Posts: 10687
- Joined: Thu Mar 10, 2005 4:59 pm
- Location: Grand Rapids
Re: Air Pressure
Passenger trains use 110 lbs and freight trains use 90 lbs. A typical freight train needs at least 75 lbs of air pressure in the brake pipe before conducting a brake test, according to the FRA.
"Remember, 4 mph is a couple, 5's a collision!"
http://flickriver.com/photos/conrail680 ... teresting/
http://flickriver.com/photos/conrail680 ... teresting/
- SousaKerry
- ALCOHAULIC
- Posts: 1158
- Joined: Sun Oct 16, 2005 9:47 pm
- Location: Somewhere north of Jackson but south of Leslie
- Contact:
Re: Air Pressure
In the past pressures were indeed lower. Don't quote me on dates but at one time passenger was 90 and freight was 75-80, I think sometime before the 50's perhaps back in the 30's. A lot of older switcher locomotives will not go above 90 PSI on the brake pipe without modifications to the brake valves. I know a certain 44 tonner that won't go above 95 PSI screwed all the way in, that is a 14L brake system.
What smells like lube oil and diesel.... Oh wait it's just my "Locomotive Breath"
-
- Railroadfan...fan
- Posts: 125
- Joined: Thu Oct 06, 2011 10:33 am
Re: Air Pressure
That is really close....To perform a class one/transfer brake test, the rear of the train (EOT or other air gauge) must be pumped up to within 15 lbs of the regulating valve on the head end locomotive, before the test can begin. Then the test may be performed, once a signal to start the test has been received, following other required protocol, such as verifying the amount of leakage, or having a 100% set of the brake on all cars, for compliance with the FRA power-brake law. that is why some of those 2-3 mile long trains don't do so well in such freezing temps.....takes FOREVER to get enough air just to do the test. (I once waited for 1 hr- 45 minutes to get my test completed on 220 cars!SD80MAC wrote:Passenger trains use 110 lbs and freight trains use 90 lbs. A typical freight train needs at least 75 lbs of air pressure in the brake pipe before conducting a brake test, according to the FRA.
-barny
- Schteinkuh
- Railcam Terrorizer
- Posts: 687
- Joined: Sun Oct 16, 2011 4:06 pm
- Location: LansingRailFan’s Mom’s House
Re: Air Pressure
I know a certain 50 tonner that..... okay I'm better off not even starting.SousaKerry wrote:I know a certain 44 tonner that won't go above 95 PSI screwed all the way in, that is a 14L brake system.
According to all known laws of aviation, there is no way a bee should be able to fly. Its wings are too small to get its fat little body off the ground. The bee, of course, flies anyway because bees don't care what humans think is impossible.